Reproduction Honda Throttle / starter / kill switch assembly for several Honda CB's. It's common for the starter button's on these bikes to wear out due to arcing or they break for various reasons. This is an easy part to replace if your wires aren't running through the handlebars, if they are, it requires removing the handlebars and feeding the wires through. Electric start sure is nice when it's reliable!
This switch is designed so the wires can run inside or outside the handlebars. There is no locator pin, so you don't have to drill a hole in your handlebars.
This switch will fit on many of the Honda CB's, check your wiring harness and make sure the connectors will work. If you have non-stock handlebars, check the wire harness length.
- Wire harness is 24" long (2ft) - Subtract an inch if you're cutting the plug off and adding bullet connectors
- Male 4 pin plug - 2 black wires connected to each other, black/white line, black/red line, yellow/red line
- Includes 4 male and 1 female bullet terminals
Honda Part Number: 35130-404-671 (Can replace part 35130-377-P00 but the wires are 13" shorter)
We also carry a reproduction of the left switch for some of the models below.
Fits Honda (Ready to plug in and go)
CB550K - 1977-1978
CB750F Super Sport - 1977-1978
CB750K - 1977-1978
NOTE: Also fits models listed below but check to make sure 23" long wires will reach your harness, the original switch had 36" long wires. For some models with taller handlebars the wires might not reach the harness.
Fits Honda - Check Wire Length! (Remove plastic plug - Use supplied terminals)
CB360T - 1975-1976
CB400F Super Sport - 1975-1977
CB550F Super Sport - 1975-1977
CB550K - 1976
CB750F Super Sport - 1975-1976
CB750K - 1976
GL1000 - 1975-1976
GL1000 LTD - 1976
and maybe others. . .